Holes configuration

Geometry Type

Sets the shape of the hole

  1. Cylinder
  2. Cube

Diameter

  • Set the diameter of the hole between 0.5mm and 100mm in 0.1mm increments.  

Penetration

  • Set the length of the hole.
  • Holes that are converted to geometry via exporting or conversion will extend infinitely till they reach the a shell of your model. If there is no void, it will punch though the entire model to the opposite side. 

Editing Mode

  • Classic – Holes can only be adjusted though the sliders or dragging the hole after placement. 
  • Advanced – Gives advanced scaling, rotation and movement controls. Available for Pro and Premium.

Last updated on