Convert holes into Caps to be used to more easily repair the model in post processing.
Cap Gap
- Sets the tolerance between the cap and the model
- Can be set between 0.1mm and 10mm in 0.1mm increments.
Hole Only
- Only The model’s mesh will be solidified, converting any selected hollowing hole into new geometry.
- Only the area occupied by both the the hollowing hole and the object will be converted.
Cap Only
- The Hollowing hole will be converted into a new object in the scene.
- Only the area occupied by both the the hollowing hole and the object will be used to create the cap.
- The Cap will have a diameter smaller then the hollowing hole, set by the value specified under Cap Gap.
Cap + Hole
- The model’s mesh will be solidified, converting any selected hollowing hole into new geometry.
- Only the area occupied by both the the hollowing hole and the object will be converted.
- Only the area occupied by both the the hollowing hole and the object will be used to create the cap.
- The Cap will have a diameter smaller then the hollowing hole, set by the value specified under Cap Gap.
Keep Cap in Place
- ON – Any cap created will remain where it was generated.
- OFF – The Cap will be moved to location 0x 0y 0x on the build plate upon generation.
Pro or Premium only
Last updated on